News

The roller is one of the key components that affect the use of the screw conveyor. According to the different uses of the roller, it can be divided into three types: the carrier roller, the idle ro...

Nowadays, the application of plastic bottle balers is becoming more and more widespread, and the number of manufacturers using plastic bottle balers is also increasing.

If the waste paper baler has a serious oil leak and the oil pump pressure is adjusted too high, the wear of the moving parts will increase the sealing space and the sealing equipment will be damaged.

The engine room must ensure the amount of air intake to supplement the air consumed by the engine combustion and a large amount of heat emitted by the unit when it is running out of the machine roo...

The installation of the unit should take into account the load on the floor, the location of the access and maintenance, vibration, ventilation, the connection of the exhaust pipe and the location ...

The voltage change rate of the synchronous generator is about 20-40%. Generally, industrial and household loads require that the voltage remain basically unchanged. Therefore, with the increase of ...

The working volume formed by the two blades and the inner surface of the rotor and the stator firstly drains oil from small to large and then from large to small.

When the diesel generator set is used in parallel, it can be divided into three working modes according to the different needs of customers.

The convenience, control performance and low failure rate of the waste paper baler control system also determine the running efficiency of the waste paper baler;

The screw conveyor has a simple structure and a wide range of applications and is favored by customers. However, in the course of specific operations, it often encounters several problems, and inev...

The difference in principle: the brush motor uses mechanical reversal, the magnetic pole does not move, and the coil rotates.

The braking device of the screw conveyor is sensitive and reliable, and it's limit clamping device should be able to independently withstand the large wind under working conditions without being bl...