1. The assembly sequence of the ibc tank forming dies is as follows: firstly install the flange connected to the barrel, then the main body of the mold, and again the parts inside the cavity such as the diverting shuttle and the mandrel, and finally the parts such as the die, the sizing sleeve and the gland.
2. When the thickness of the product is uneven, adjust the gap between the die and the mandrel. This type of barrel should pay attention to loosen the screw on the thin side and then tighten the screw on the thick side to avoid damage to the part or to break the screw.
3. If the molding die is not used temporarily, the parts should be assembled after oiling, and the inlet and outlet ports should be sealed and stored on a wooden rack in a dry and ventilated place. No heavy objects should be placed on the mold.
4. The connecting bolts and adjusting screws should be coated with a layer of molybdenum disulfide or silicone oil before installation, which makes it easier to disassemble in the high-temperature environment.
5. When cleaning and trimming the mold discharge port, it is not allowed to use the edge of the mold or remove the metal burr. Only the fine oil stone or fine sand cloth can be used to round the corners and burrs of the discharge port and smooth it.