The reason why the waste cardboard baler has a bad bonding effect is that the temperature may be too high or not enough. If a special belt is used, the viscosity is poor and very accurate temperature is required; It may be that the voltage is not enough. At this time, you can choose to use it and you must use the extension cable. You need to connect the wires that are thicker and not too long. It may be that the bearing under the middle knife of the baler is broken, which will cause heating and cannot be bonded at all;
The long pull spring on the electric swing rod of the waste cardboard baler is damaged, and the effect of poor adhesion may occur due to the inability to pull the strange hand to the position; The position of the electric steel sheet of the baler is not accurate. It is too high or too low or too far left and right. If it is too high or too low, it will hit the upper and lower pp belts. If the left and right sides touch the left and right tools, it will not enter the heating. Should be adjusted according to the specific circumstances; If the micro-fan used in the automatic baler for exhausting smoke fails, it will also cause the temperature to be too high, which will affect the packaging effect.
The reason why the waste cardboard baler does not stop feeding: the potentiometer of the belt is faulty, as long as it is replaced; The green button or other fault appears on the button of the belt, as long as the button is replaced; If it is not tied, it will be cut off: the looseness of the waste cardboard baler is too tight, just tighten it; The position of the ls3 and ls5 of the waste cardboard baler is not suitable; the failure of the switch of the magnetic cardboard baler with the magnetic induction is broken.