In the operation of the screw conveyor, depending on the design strength of the screw conveyor, the design of the article in the design of the item being transported. Screw conveyors and various tissues should be smooth: The reducer of the drive unit is applied to every 10 oils, and the oil is changed every three months. The bearing housing needs to be filled with high-temperature smooth grease.
Non-professionals must not touch electrical components, control buttons, etc. It is not possible to disconnect the rear stage of the inverter during the operation of the screw conveyor, for example, affirmative maintenance. Adjust the demand under the condition of the cutoff frequency operation, otherwise, the inverter may be damaged. Turn off the screw conveyor and press the cut button to cut off the total power of the system after cutting off.
The basic of the screw conveyor should be irrigated 20 days before the official installation of the screw machine. Screw conveyor housings require high temperature and smooth grease; It does not cause the screw machine to sink or deform, and the screw machine operates. Usually, after installing the housing, the base of the screw machine is bolted to the bracket. The base and the outer casing are welded firmly and the bracket and the casting are substantially welded together.
After installing the screw conveyor, connect the power supply and check that the spiral direction of the helix is the same as the turning indicator of the screw conveyor. If you do not need to connect from the head, you should replace the cord set. The feed of the screw conveyor should be average, otherwise clogging is simply formed in the conveying material, causing the drive to be overloaded and mechanically damaged.